SWINGARM

REMOVAL

BRAKE CALIPER

SWINGARM

Remove the following:

— Rear wheel (page 15-8)

— Brake pedal (page 16-24)

Do not disconnect Remove the rear brake caliper from the slide rail on

the hydraulic line, the swingarm.

NOTICE

Do not suspend the brake caliper from the brake hose. The brake hose may be damaged.

SWINGARM

SWINGARM

IBRAKE HOSE GUIDES

Remove the screws and brake hose guides.

Check the chain guide slider for wear or damage. Remove the following:

— Bolts

— Nuts

— Chain guide

— Chain guide slider

— Collars (’05 — ’07)

— Drive chain (page 4-25)

Raise the rear wheel off the ground by placing workstand or equivalent under the engine.

Remove the shock arm bolt, nut and washer (swing­arm side).

SWINGARMRemove the pivot nut and washer.

PIVOT NUT/WASHER

SWINGARM

Remove the pivot bolt and swingarm.

PIVOT BOLT

CHAIN SLIDER

SCREWS

SWINGARM

DISASSEMBLY

Check the chain slider for wear or damage. Remove the screws and chain slider.

BEARING

DUST SEAL

NEEDLE BEARING

SWINGARM

Remove the following:

— Side collars

— Dust seals

— Washers

— Thrust needle bearings

— Pivot collars

Check the dust seals and collars for wear, damage or fatigue.

Check the needle bearings for damage or loose fit. Check the thrust needle bearings for wear or dam­age, replace it if necessary.

Check the swingarm for cracks or damage.

Replace any damaged parts, if necessary.

WASHERS SIDE COLLAR

Добавить комментарий

Ваш e-mail не будет опубликован. Обязательные поля помечены *

Confirm that you are not a bot - select a man with raised hand: