STARTER RELAY SWITCH

INSPECTION

STARTER RELAY SWITCH

STARTER RELAY SWITCH

Remove the left side cover (page 3-3).

Shift the transmission into neutral.

Pull the clutch lever fully, and push the engine starter switch.

If the starter relay switch "CLICK", the coil is normal.

If you don’t hear the switch "CLICK", inspect the starter relay switch using the procedure below.

STARTER RELAY SWITCH

4P CONNECTOR

GROUND LINE

Disconnect the starter relay switch 4P connector.

Check for continuity between the Green wire termi­nal of the wire harness side connector and ground.

If there is continuity, the ground circuit is normal.

POWER INPUT LINE

STARTER RELAY SWITCH

4PCONNECTOR

Connect the starter relay switch 4P connector.

Shift the transmission into neutral.

Pull the clutch lever fully, and push the starter switch.

Measure the voltage between the Yellow/red wire terminal (+) and ground (-).

If the battery voltage appears only when the clutch lever is pulled fully and starter switch is pushed, the circuit is normal.

OPERATION CHECK

STARTER RELAY SWITCH

© 0 BATTERY

Remove the starter relay switch (page 19-14).

Connect a fully charged 12 V battery positive wire to the relay switch Yellow/red wire terminal and the negative wire to the Green wire terminal.

There should be continuity between the cable termi­nals when the battery is connected, and not continu­ity when the battery is disconnected.

STARTER RELAY SWITCH

4PCONNECTOR

REMOVAL/INSTALLATION

Remove the left side cover (page 3-3).

STARTER RELAY SWITCH

STARTER RELAY SWITCH

Disconnect the starter relay switch 4P connector. Pull out the starter relay switch from the rear fender.

Remove the bolts and disconnect the starter motor and battery positive (+) cables.

Installation is in the reverse order of removal.

LIGHTS/METER/SWITCHES