ASSEMBLY

O-RING

DUST SEAL WASHER

INSULATED WASHER

SHIM ARMATURE

BRUSH

FRONT COVER

SEAL RINGS

SHIMS

BRUSH SPRING

WASHER

INSULATORS

O-RING

MOTOR CASE

BRUSH HOLDER INSULATOR TERMINAL BOLT

INSULATOR PLATE

REAR COVER

3.4 N m (0.3 kgf-m, 2.5 Ibf-ft)

INSULATOR

TERMINAL BOLT INSULATORS

ASSEMBLY

WASHER

ASSEMBLY

O-RING ^

Install the following:

— Insulator

— Terminal bolt

— New O-ring

— Insulators

— Washer

— Nut

— Insulator plates

SCREWS/BRUSH/WASHERS

ASSEMBLY

INSULATOR PLATES

ASSEMBLY

— Brush holder

— Washers

— Brush

— Screws

— Brush springs

ASSEMBLY

SPRINGS

BRUSH

ARMATURE

BRUSHES

ASSEMBLY

Apply grease to the armature shaft end.

Install the shims properly as noted during removal.

Install the shims onto the armature shaft.

Install the armature onto the rear cover while push­ing the brushes into the brush holder.

Align the motor case groove to the insulator tab.

MOTOR CASE

REAR COVER

ARMATURE

ASSEMBLY

Install a new seal ring and motor case to the rear cover while holding the armature tightly to keep the magnet of the case from pulling the armature against it.

NOTICE

The coil may be damaged if the magnet pulls the armature against the case.

Apply grease to the oil seal lip and needle bearing in the front cover.

WASHER

ASSEMBLY

SEAL RING

INSULATED WASHER

FRONT COVER

ASSEMBLY

Install the washer by aligning its tabs to the front cover grooves.

FRONT COVER

ASSEMBLY

Install the shims Install the shims and insulated washer onto the properly as noted armature shaft. during removal. Install a new seal ring onto the motor case.

Install the front cover being careful not to damage the oil seal lip.

ASSEMBLY

Tighten the motor case bolts to the specified torque.

BOLTS

ASSEMBLY

ASSEMBLY

Coat a new O-ring with oil and install it into the starter motor groove.

TORQUE: 3.4 N m (0.3 kgf m, 2.5 Ibf-ft)

INSTALLATION

STARTER MOTOR CABLE

Install the starter motor onto the crankcase.

Install and tighten the starter motor mounting bolt. Install the starter motor cable and terminal nut onto the motor terminal.

Tighten the nut securely.

Install the rubber cap over the motor terminal prop­erly.

Install the cylinder (page 10-10).

ASSEMBLY

ASSEMBLY

STARTER MOTOR

BOLTS — Я RUBBER CAP

Добавить комментарий

Ваш e-mail не будет опубликован. Обязательные поля помечены *

Confirm that you are not a bot - select a man with raised hand: